Pass Along DM
March 08
One Way to Set a Tool
by George Bulliss
hen setting a tool length offset or Z position, many people simply jog the tool down to the work surface until it touches the work or a piece of shim stock. This works fine, and I used this approach for many years. There were occasions, though, when I accidentally jogged too far down and a chipped cutter, a mark in the part, or both resulted.
There are times when I still have to touch a tool directly off of the part, but the majority of my tool setting now takes place one inch above the part. I now jog the tool down to a little under an inch above the part and then slowly jog up until I can just slide a one-inch spacer block under the tool.
By always moving in a Z-positive direction, crunched tools are now a thing of the past. Most modern controllers will allow you to easily subtract an amount off the value that is entered into the tool table. Even if you have to do the math and manually enter the new figure, it is a quick and easy way to set a tool.
For a really neat discussion on the use of CNC in artistic applications, check out this thread on our Bulletin Board.
Please do us a tremendous favor and forward this e-mail on to your machining friends!
Are you not a subscriber to DIGITAL MACHINIST? Visit us at www.homeshopmachinist.net and request a no-obligation issue, or call and request it at 1-800-447-7367. Tell them you received an e-mail from a friend!
Your friend thinks you’ll enjoy DM, or you wouldn’t have this e-mail!
We hope you enjoyed this e-mail tip, brought to you by your friends at Digital Machinist.
We hope you enjoyed this e-mail tip, brought to you by your friends at Digital Machinist , dedicated to precision metalworking.